I am trying to rebuild a Briggs & Stratton carburetor and need a detailed drawing of it. It's the on on the Model GH-410 engine for the Generac Generator. The part number is 0A4600.

Try [url]www.briggsandstratton.com. You'll need the model, type and code from the engine.

Try www.briggsandstratton.com. You'll need the model, type and code from the engine.

Thanks but it is not on the website. Been there done that. I have all the manuals but they do not have detailed drawing of the carburetor.

Believe I found it here: http://www.oscar-wilson.com/MANUALS/GENERAC/0E7300A.PDF

What are the numbers, if, any stamped on the blower housing. They are usually difficult to see. There should be a model, a type and a code stamped there.

Thanks again. But the drawing is the same as the one I have in my manual. It just shows the carburetor but doesn't break it down to show float, bowl, internal components, etc.
Thanks

Hi,
Then try the voluminous list of repair procedures at Outdoor Power Info(one of three sites done by Outdoor Equipment Distributors) at:
Small Engine Equipment Troubleshooting, Repairs and Safety (http://outdoorpowerinfo.com/repairs/)
Peace,
Clarke