I have a kenmore 80 series dryer that turns on and off, tumbles but blows cold.
Heating element is not broken . Before I call in a repair technicain has anyone run in to this before.

Since you've ruled out the element, my guess is that the thermal fuse has blown.

Here (https://www.askmehelpdesk.com/appliances/kenmore-dryer-not-starting-209359.html#post1011867) is a link that may prove useful.

The thermal fuse is generally really easy to test (with an ohm-meter) and replace.

Also, while you're back there clean out the lint from the vent pipe and the dryer itself.

Best of luck,
WallyH

I like to check voltage to element, and if present, and amprobe shows no current, then it is open.
Since Element is good, I would turn Dryer on, measure across thermals, If 1 is open, it will show voltage. Usually more than one will not go out at the same time.