I Have a Miller Single Package Heat Pump That I have been having some trouble with for a little while now. It started with where the fan would not cut off. By the fan being in a consent run it burnt my fan motor up. I temp installed another fan to see if I could isolate the problem. After installing the new fan I hot jumped it to try to isolate the problem. Well this worked, but then after buttoning everything down it didn't work at all. I have tried everything to my last resource and now I am at a standstill. I have tried different control boxes inside the house. Tracing wires and checking for burnt or scorched places on the wires or the boards. I think that my problem is that I may have burnt up the boards on the unit. But, I would really like to get some info from someone who may know more about this than I do. Thank you for any suggestion from which anyone may choose to share.


Thanks Greatly,
Danny Reynolds

Danny, I think the HVAC section of this site would be a better place to post this.

Heating & Air Conditioning - Ask Me Help Desk (https://www.askmehelpdesk.com/heating-air-conditioning/)