Hello,

My Frigidaire Washer (Model #LTF2940EE0) goes through all the wash cycles just fine except for the final spin cycle. The clothes are soaking wet! I purchased it just barely two years ago. I've looked online at other postings and I'm not sure if it's the motor or the sensor board. Also if it is the motor, exactly how long the motor is under warranty. I moved recently and can't seem to locate my paperwork to know for sure. Can anyone help diagnose this problem for me please? Thanks in advance.

Some folks have noticed that the door switch was preventing their washer from going into the spin cycle.

Here (http://www.acmehowto.com/howto/appliance/washer/check/lidswitch.php) is a link to a test procedure, but first I would just press the switch down with a pencil or something to see if there is just a mechanical problem (such as a broken plunger).

Good Luck,
WallyH

Does it pump all of the water out. These washers are notorious for collecting lint in the pump, slowing downs the pump out. You can take the bottom front panel off the washer and access the pump from there, if it proves to be a slow pump out. Remove the front of the pump and clean it out.