I just purchased a ultra 3 155 BTU boiler and need to wire two zones valves and a indirect hot water heater to it. The manuel only tells how to wire to circulator pumps and not zone valves. I used honeywell V8043e zone valves and I'm not sure how to wire them into the boiler.

Thanks
Kevin @ [email protected]

This is a set of instructions from Honeywell. It has examples of wiring. All the info you need is contained in the link below. If the information contained in the link does not satisfy your requirements you will need to call for ON Site Service to figure out your wiring because it is nonstandard and will need greater care to make sure no damage happens.

http://customer.honeywell.com/techlit/pdf/95c-00000s/95C-10932.pdf