Log in

View Full Version : Neptune Dryer Stopped Heating M/N MDG4000BWW


grega223
Jun 7, 2006, 03:51 PM
Hi, Please Help! My girlfriends dryer stopped heating suddenly. It's a Maytag Neptune Model MDG4000BWW. There is no heat whatsoever. I am hoping there is something inherent with this model that I can start with. Any suggestions will be greatly appreciated. Thanks.

applguy
Jun 7, 2006, 04:13 PM
First, you must remove the front panel. Open the door and remove 2 screws on each side of the opening; 2 in the door hinges and 2 directly opposite from them. Then close and latch the door and pull on the top corners of the panel and it pivots down, then lift off the bottom brackets. Then start the dryer (making sure it's not set for air fluff or no heat) and watch the ignitor to the left side of the burner tube. Report back if it glows or not. Also you might include the first two numbers of the serial number so I can make sure we're talking about the same series machine.

grega223
Jun 7, 2006, 05:15 PM
Thank you very much. I will do that tomorrow and report back!

afecci
Jun 13, 2010, 10:51 AM
I have a maytag gas dryer
MDG4000BWW the heat comes on but only for a few minuets the goes out. If you wait about 1hr then try again the heat will come on the go out in a few minuets

chuck7641
Sep 19, 2010, 07:42 AM
Yes glows gas valve opens main burner comes on once cycled off< glows again but valve does not open