Log in

View Full Version : Pop up bath drain


stoneage
Sep 25, 2008, 05:00 PM
I have a step on drain in my shower/tub. I took it out to clean some hair and gunk, but now I can't seem to get it back in properly. It has a brass screw that attaches it to the drain and a sliding plastic body that clicks up and down to seal the drain hole. It doesn't seem to seat completely after reinstallation. Does anyone know how to adjust this type of drain? Thanks for any help.

ballengerb1
Sep 25, 2008, 05:10 PM
That brass bolt is threaded into the drain body and then your stopper threads onto it. The bolt can turn in the body as well as in the stopper, just keep turning several more full turns.

stoneage
Sep 25, 2008, 05:15 PM
Thanks for the quick response. I just have to turn that big standard screw head, and that will draw the pop up body closer to the drain? And then the stopper head screws on to the top? Is the pop up itself adjustable in any way, or is all the adjustment done with the brass screw?

ballengerb1
Sep 25, 2008, 05:16 PM
The brass screw is your only adjustment.

massplumber2008
Sep 25, 2008, 05:22 PM
If I get this issue right... click the stopper so that it is in the UP mode (pretend to step on it a couple times). Then install the part with screw at its longest... then screw on stopper cap.

Let me know if this is it?

MARK

stoneage
Sep 25, 2008, 06:18 PM
It really doesn't matter if the pop up is in the up or down position. It is independent of the open/shut system. The brass screw only goes so far; after I turned it in till it bottomed out everything worked fine.

massplumber2008
Sep 25, 2008, 06:27 PM
You know... I worked on one of these just last week. Just like you said! I got caught up in the popping up/down...

Thank you for update!