Hello: I have a Kenmore Type 575-0 Model 665.743823 that is about 3 years old.

For the past 6 months or so the glasses always have dirt on the inside of them when the load has finished. For the past week, when the load is finished, the bottom of the washer is full of water. If I press the Cancel/Drain button the water does drain out.

I took the bottom sprayer and grey filter out and removed bones, foil, etc. that had accumulated in the bottom. I took the cover off the grinder part and cleaned it out as well. Put everything back together and ran another load. Still the water is left over at the end of the entire cycle. I can hear water draining out whenever it is supposed to, through the entire cycle and the water at the bottom is clean, so I know it has been draining throughout when it should. It is just at the end of the last rinse it does not appear to drain.

Any suggestions?

Thanks

Remove the drain hose and clean it. Also clean the port where it connects to the was disposal or sink drain

Remove the drain hose and clean it. Also clean the port where it connects to the was disposal or sink drain

Sorry. I should have mentioned that I already did that. Nothing was blocking the hose and the drain pipes under the sink are clear. I also checked the trap.