dyiurslfr
Aug 14, 2008, 09:12 AM
I just finished installing a 5-piece tub surround kit. I applied a 1/4" bead of adhesive around the edges of the corner panels before attaching it to the two side panels. However, after drying, there is still a small gap between the corner panel edge and the side panels.
The attached picture shows the corner panel wth the tape I used to try to hold the panels together, as per the manufacturer's instructions. There's still a small gap where the panels meet.
Should I try to squirt some more adhesive into the seam or just caulk it from the outside and be done with it?
11108
The attached picture shows the corner panel wth the tape I used to try to hold the panels together, as per the manufacturer's instructions. There's still a small gap where the panels meet.
Should I try to squirt some more adhesive into the seam or just caulk it from the outside and be done with it?
11108