How do I fix my washer? It is not working in the drain cycle.

Standard washer action when pump is not working properly :

First : close the water inlet tap.

Than remove pump hose from pipe and put into drain or bucket. You do not want all that water to drain over your floor. Make sure the drum drains properly (if too slow check later also the hose for blockage).

To check the water pump : open up the pump cover (at bottom front). Be ready to collect remaining drain water!! Remove any obstructions. Check also the access hole to the inner drum.

Close the pump cover.
If you want to check the hose do it now, by blowing through the outlet section towards the washer. When clean , re-install the pump hose.
Open the water tap. Check the washer and pump operation.
If you still have a problem - and have a multi meter - you can do more tests if you want.

Just let me know.

Success !

:)