I just installed a new bathroom in my basement. The toilet has a good flush action but just fills with water. It does not have the suction to flush a piece of tissue. The water evenutally seeps out to the correct level.

I have tried two different toliets and wax rings but still have the problem.

What can I do to resolve?

Sorry it took so long to reply. Your question should have been directed to the plumbing page. In my capacity as shop trouble shooter I began to run into a slew of complaints on our new construction that were just like yours. I knew they all couldn't be " bad toilets" so I went looking for the cause. I found that when installing the new bowl that the wax ring had been forced out into the discharge pipe and blocking the free flow of water. When the water hit it a backpressure was set up preventing the siphon that makes a good flush and the solids just swirled around while the water went slowly down. I had to set up meeting with our plumbers and show them the problem and how to fix it. When you set the bowl, put the wax seal down on the flat side to the closet flange. Then take your hands and bevel the wax seal outward so that when you set a bowl on it the wax is forced out instead of in blocking the flush. The customer complaints stopped and I had less work to do. Try molding the wax seal so it doesn't choke down on the flush. Good luck, Tom