Log in

View Full Version : Toilet Vent


Steve1445
Mar 9, 2008, 06:48 AM
While taking out a bathtub I discovered a vent for the toilet. Looks like it runs straight up to an attic space (not a sealed space, outside air passes through at will) and not through the roof to the outside. The wall that it is in is perpendicular to the main wall to the room and I would like to reduce this wall to a half wall. My question is: does the vent have to go straight up, or can I put a 90 degree bend and reroute it to another attic (sealed space) behind the main wall of this room. And, is there a minimum height for the vent that I have to watch out for. There is also a main vent for the bathroom and laundry about 9 feet from (downstream) this newly discovered toilet vent.

massplumber2008
Mar 9, 2008, 07:08 AM
Hi Steve.

The vent does not have to run straight up... so a 90 degree turn over and then another 90 degree turn up will be fine.

Code says that that vent needs to tie into the main vent just before it penetrates the roof.. or exit the roof by itself.

Hope that answered your question... MARK

If this helped, please RATE THIS ANSWER. Thnak you.


.

Steve1445
Mar 10, 2008, 03:45 AM
Hi Steve.

The vent does not have to run straight up...so a 90 degree turn over and then another 90 degree turn up will be fine.

Code says that that vent needs to tie into the main vent just before it penetrates the roof..or exit the roof by itself.

Hope that answered your question...MARK

If this helped, please RATE THIS ANSWER. Thank you.


.

Thanks Mark, just the info I needed. Steve