So I have a very expensive high quality roller and it left a LOT of fuzz on the wall.. unfortunately I didn't see it until after the paint dried.

What can I do? I was thinking of just going over it with a very thick primer and then repainting.. will this work?


I learned after the fact how to properly prep my roller with masking tape fuzz removal...

Thanks,
Knucklez

Yes you must use proper fuzz removal methods. That just sounds important. You might try and lighty sand those areas with 220grit sand paper, maybe use a pole sander, not a power sander. Good luck

Thanks for the advice. I got some 220 and tried it a bit by hand to see if it would work. No problem, works great.

Just is a pain in the ;)

Well, some things you learn the hard way :o

Knucklez