How do I clear the flashing filter light on my thermostat? I have changed my filter.

Press the "i" key, then the up arrow, then run program.
Here is a site for your operators manual; (Page 17) [url]http://honeywell.com.au/business/acs/acp/ecc/manuals/T8602_%28chronotherm I.pdf
Hope this helps, Mike

How do I clear the flashing filter light on my thermostat? I have changed my filter.
I read one post that was incomplete and confusing. The answer is... In fairly rapid sequence... Press the "i" button, then open up the flap and press the "^" button under "Time" and then press the "Run Program" button. That will clear the flashing "filter"

Here

http://customer.honeywell.com/techlit/pdf/69-0000s/69-1507.pdf

I read one post that was incomplete and confusing. The answer is...In fairly rapid sequence...Press the "i" button, then open up the flap and press the "^" button under "Time" and then press the "Run Program" button. That will clear the flashing "filter"

You copied my answer to to a question posted by another person and said it was incomplete! Can you read? Or do you need an interperter?

How do I get rid of the flashing filter sign after I have already replaced the filter
:confused:

This did not work -- Filter light is still blinking

After you press the "I" button, you will get a reading that states the number of days remaining for "Air", this refers to the days remaining before the air filter change is supposedly needed. If the "filter" is flashing, the number is probably "0". Using the up arrow next to "wake", increase that 0 to as high a number you can, usually 30 or more. Then press "run program." This will get rid of "filter" for those number of days. Then you need to repeat.

How do you use the copy function?