Log in

View Full Version : Replace and intall garbage disposal


amma92
Aug 28, 2007, 03:11 PM
My disposal just died with water and things in it and the water will not go down. Can I, a none plumbing person, replace and install this on my own? I have absolutely no knowledge of this type of matter other than sticking a broom handle down it did not work and I pushed the little button and it did not work either. :confused:

ballengerb1
Aug 28, 2007, 03:16 PM
Before you replace it lets make sure it isn't simply jammed. Take the little wrench that came with it, slow S shaped allen wrench, insert it dead center from underneath. It should fit into a small hole. Move the wrench clockwise a few times and then counterclockwise a few more. Try your switch to see if it is unjammed. If not come back and I'll walk you through the replacement procedure. It is fairly easy and straight forward.

biggsie
Aug 28, 2007, 06:48 PM
What happens when a motor locks up , did the overload trip (button on motor)

Have you checked to make sure a breaker is not tripped , worth checking

cpalmist
Aug 28, 2007, 06:54 PM
I'm a bit unclear as to whether you did get the disposal unjammed or not. You may have a bone frag or a dish fragment jamming the disposal so using a flash light to look down inside the thing look at the angle between the wall and the floor of the disposal and see if you can spot what the obstruction is, if you weren't able to unjam it. I found a loose screw jamming my disposal one time - once I got it out it ran fine.

afaroo
Aug 31, 2007, 03:22 PM
Very good respod it has happened to me couple times