Log in

View Full Version : Monitor "standbying" after replacement of fans


teebo
Aug 12, 2005, 01:25 PM
This problem has been solved - solution at the bottom.

My PC:
Windows XP Home
AMD 64 3000+
1 GB RAM
NVIDIA 6800 LE 128 MB
Asus K8N motherboard
- and I never clock
---------------
I recently did the following to my PC:
- replaced my noisy CPU fan with a better, more silent one
- replaced my 300 W power supply with the best from Hiper (580 W I think)
- replaced my terrible video card fan with a Thermaltake fanless cooling set (keeping it below 50 degrees)

(Before I got everything working with the new parts, I started the PC a few times with only beeping as the result (but quickly turned it off). One time I had forgotten to give the Asus its power :rolleyes:, and the other time I forgot to give the video card power.)

MY PROBLEM:
My monitor now goes into standby-mode immediately after starting the PC, and never snaps out of it. I checked that the fan-power input on the video card delivers power. All fans run fine (and silently :p) - but this ain't worth much as I can't see SH*T on my monitor. :confused:
Please help me solve the problem. I read somewhere that the BIOS can get reset at power accidents etc... but anyway, what are your suggestions?
Thanks in advance.
- teebo

labman
Aug 12, 2005, 06:34 PM
Stand by works off the horizontal or verticle snyc signals. Wiggle the video card around in its slot with the power off, and try it. If that doesn't help, maybe by that time some of the good people here will have answered.

teebo
Aug 13, 2005, 06:00 AM
Thank you for the reply.
More important info:

I have tested the PC with a different video card (an a bit older nVIDIA), but this didn't help.

psi42
Aug 13, 2005, 12:46 PM
Is the machine booting up or even POSTing?

If not, reseat _everything_ -- power cables, IDE cables, RAM sticks, PCI cards -- the lot. It is possible something is just loose in its slot.

teebo
Aug 13, 2005, 01:32 PM
The things I observe when I start the computer, are that all fans start to hum, the monitor goes on, but immediately goes into standby. Then it just stands there humming. I have no startup sound, so I can't tell if it's getting into Windows.
I do not know what POSTing is :o

Thank you for the tip, I'll try turning all power off and reseat everything well, then turn the power back on and start up. It'll be a few days until I see my PC again (moving) but I'll report back as soon as I've tried this.

teebo
Aug 17, 2005, 09:45 AM
The problem is now solved - I found that the CPU was not properly inserted, and that in fact, a few of the pins on the CPU were bent! (So actually, none of the PCs components other than the fans (power) were working).
I managed to bend them back without breaking anything. Lucky.

So thanks for the tip - something was indeed loose in its slot!

LTheobald
Aug 18, 2005, 01:11 AM
I've been experiencing a similar problem recently. Guess I better check my CPU too. Cheers for posting the result and well done for editing the post to show it was solved.