I took my mower apart to sharpen my blades, now I am having trouble putting it back together. Can you show me the blue print of the John Deer L110 so I can see what I did wrong

I took my mower apart to sharpen my blades, now I am having trouble putting it back together. Can you show me the blue print of the John Deer L110 so I can see what I did wrong
Took my mower deck apart on my John Deer L110, now I am having problems putting it back together. Lost my manual and I can't tell where the cord goes to.

I build these units. What "cord" are you talking about? There are no cords on it. Explain further and I will help you or scan and try to attach page out of manuel to help you out

It only takes one nut per blade to remove for sharpeneing, no cord involved. Did you rebalance the blade when you were done sharpening, you should.

Are you talking about the cable that with a spring at the end of it? If so, the spring connects in the plate of the tenson pully( the small pulley in the middle of deck) and the cable housing pushes through the gold bracket on the left side of the deck. Then a clip goes on the back side if that thur the cable housing. That cable is what pulls tension on the belt when you push the level up to engage the blades. Hope this gets you back in business