Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Connecting to 1 1/2" copper drain with pvc kitchen sink drain trap
[ 8 Answers ]
I'm trying to rehook up the kitchen sink pvc trap to the old copper drain pipe but the connector doesn't fit tight enough and the water links out. Any ideas how to stop this leak?
Adding drain for washing machine - do I need a pea trap and vent?
[ 4 Answers ]
I am installing 2 new washers and dryers on each floor in our two flat in a kitchen pantry (the building is 120 year old frame building.) We are installing the wall insert that has the hole for the water coming in and a hole to put the drain hose going out. I know it has to be about 42" off the...
Washer drain overflow - plumbing diagram - do I need additional air vent
[ 3 Answers ]
Hi, I have a 3" sewage pipe that runs from the basement floor to the roof. I cut about a foot of the sewage pipe and connected a 2" pvc pipe with 2" trap for the washer drain line. I am getting over flow from the stand pipe. There is no blockage of the sewage pipe. When I cut it open, it was...
Vent diagram - does this meet code (see pic)? Vent runs below actual drain
[ 4 Answers ]
The schematic below should make it clear the configuration I would like to use. Basically, I would like to keep the vent under the floor for a little ways, so it pops up in a better location. I cannot easily move the 2" drain location going down and would rather not go straight up from the...
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all... View more questions Search
|