Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
John Deer Hydro 175 - blades engaged kill engine
[ 8 Answers ]
Issue: When blades get engaged the engine sometimes stops, when sitting for a 5 minute length of time the enging stops. Have Tried: I disconnected the safety plunger under the seat. This did work for a little while then same issue. I just bought this from my brother, he had told me of this...
Lawntractor blades will not stay engaged
[ 1 Answers ]
I just changed the blades on my Yardman Lawn Tractor. And now the lever that engages the blades will not stay over. I pull the lever left to right and it usually stays in place and the baldes stay engaged. I removed the deck to change the blades. It seems simple enough, I only had to un loop...
John Deere 316 dies when hydro engaged
[ 2 Answers ]
I have a 1986 John Deere Model 316 riding tractor. I have a problem with a safety switch somewhere that I cannot seem to locate. When I start the motor and try to engage the hydrostat or the pto, it dies. I have replaced the switch on the hydro control and cut the wires on the seat switch and...
Bolens 15.5 38 in cut. Tractor jerks w/ blades are engaged
[ 2 Answers ]
When I engage the blades, The whole tractor jerks pretty hard in a way, should I say( like a missing tooth on a gear) Seems to do it more while turning or going up hill. When I disengage the blades the jerking stops and the tractor acts fine, as long as the blades aren`t spinning. Pullys... View more questions Search
|