Ask Experts Questions for FREE Help !
Ask
    tobysoman's Avatar
    tobysoman Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 22, 2012, 11:32 AM
    question about electronic circuits
    Design the voltage amplifier shown below to achieve the following specifications:
    Open circuit voltage gain vout/vin =7 V/V ± 5%
    Input impedance > 5 kW
    Output impedance < 40 W
    Total power dissipation < 45 mW.
    Design for maximum allowable voltage swing at the output and ignore the Early effect.
    Transistor parameters: b = 200 , IS = 1 fA , rb = 0.
    smoothy's Avatar
    smoothy Posts: 25,492, Reputation: 2853
    Uber Member
    		  
    #2

    May 22, 2012, 11:35 AM
    Quote Originally Posted by tobysoman View Post
    Design the voltage amplifier shown below to achieve the following specifications:
    Open circuit voltage gain vout/vin =7 V/V ± 5%
    Input impedance > 5 kW
    Output impedance < 40 W
    Total power dissipation < 45 mW.
    Design for maximum allowable voltage swing at the output and ignore the Early effect.
    Transistor parameters: b = 200 , IS = 1 fA , rb = 0.
    What have you come up with already since this is homework and we don't simply hand out the answers... we will however help you after you present what you have already done... per the site rules.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electric circuits [ 2 Answers ]

The location is in a finish basement which will have a small enclosure 3'*3'*4’ high, hiding sump pumps and drain pipes to the outside. It is recommended to put the pumps on two different circuits; one will be on an existing 20amp circuit using 12/2 and is running 3 receptacles protected by a...

Need more circuits! [ 2 Answers ]

I am trying to add a few more 240V circuits for a welder and plasma cutter in the shop. The 200 amp panel is already full (4 30amp, A LOT of 20 amp, and a 100 amp service piggybacked). I have a new 200 amp service set at a barn about 50 ft. from the shop. Can I run another 100 amp service into...

Circuits [ 2 Answers ]

Suppose that the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. (a) Find the steady-state current in each resistor. R1=16.00 kΩ, R2=12.00 kΩ, and R3=2.00 kΩ. (b) find the charge on the capacitor. 9.00V, 10.0uC I found part (a) but I'm...

Electronic Circuits of Remote Control of Ceiling/Cabin Fans [ 2 Answers ]

What is the circuit diagram of Remote Control of Domestic Ceiling or Cabin Fans?

Basement wiring (question of separate circuits) [ 15 Answers ]

Hi, I will be wiring my basement soon (about 1400sqf) with one family/TV room, a bedroom, an office and a bathroom. They ran only one 15AMP circuit that currently operates basement lights (8 of them) and 2 GFI outlets. They also put each bedroom upstairs on a separete circuit breaker with a...

View more questions Search