Ask Experts Questions for FREE Help !
Ask
    bronco bob's Avatar
    bronco bob Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Aug 20, 2008, 01:38 PM
    Starting Briggs & Stratton 10HP engine that has not run for 2-yrs
    Cleaned plug, put a little gas in chamber, put new gasoline in tank and still won't start after many tries. Has the old gasoline caused the problem and do I need to clean carb?
    Bronco Bob
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Aug 20, 2008, 01:40 PM
    Did it sputter? Do you have spark?
    bronco bob's Avatar
    bronco bob Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Aug 20, 2008, 01:51 PM
    No sputter. I can't tell if I have a spark. Unit only has about 10 hours total time. No reaction at all from the engine. Bronco Bob
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #4

    Aug 20, 2008, 08:18 PM
    To test spark: remove plug and keep HV wire connected. Hold against block with an insulated object. Crank engine. Should spark.

    If no spark, then change plug and look for safety switch problems.

    Even if the fuel system is bad it should sputter. Spray carb cleaner should be used as "starting fluid".
    bronco bob's Avatar
    bronco bob Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Aug 20, 2008, 08:42 PM
    Thanks! I'll give you feedback later!
    Bob
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #6

    Aug 20, 2008, 08:44 PM
    OK, read the sticky at the beginning of this section. Some useful info is there for future reference.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

10HP Briggs and Stratton Generator Engine [ 24 Answers ]

Hi Guys, Recently, I was using my Generac 5550 generator with a 10HP Briggs & Stratton OHV, model 204412, Type 0142 engine, and it started running rough and puffing black smoke. So I bought the repair manual. Took everything apart to the piston, cleaned the carbon off the pistons and...

I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]

I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...

14.5 Briggs and Stratton engine [ 1 Answers ]

Can someone please tell me how to adjust the valves on a 14.5 over head valve engine? Thanks, roustaboutx

12.5 briggs&stratton engine [ 1 Answers ]

I have a briggs &strattonengine in my ride on lawn mower the battery won't charge when the engine is running

View more questions Search