Ask Experts Questions for FREE Help !
Ask
    JohnTyler1984's Avatar
    JohnTyler1984 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 10, 2012, 11:03 AM
    Snapper blower 17243 won't stay on.
    My Snapper snow blower model 17243 will only run for a few seconds, if it starts at all. I've choked the engine, and fuel and oil levels are fine.

Check out some similar questions!

Snapper mowerLX1642H won't stay running [ 1 Answers ]

It starts fine and runs but as soon as I let of clutch it dies

Leaf blower won't stay running [ 8 Answers ]

I have a Craftsman Blower/Vac Mulcher. 32cc, 170 MPH, 360 CFM. I can get it to start just fine and it will go to full RPM when I hit the throttle but weather it is full throttle or just idle, it will kill after about 5-7 seconds or so every time. The choke is off and the gas is new (few months...

Echo leaf blower won't stay on [ 2 Answers ]

My echo leaf blower turns on but when I give it gas it gose off. Spark plug is new. Air filter is new to. I should add that it's about 6 years old and went a year with out the air filter while in use.

Blower won't stay on [ 1 Answers ]

Hello, I have a Intertherm Oil Furnace Model# MAC 1265 Appliance No.F000194504. Not sure about the year it's old, yearly maintenance done though. The furnace turns on and starts heating then shuts off. The blower turns on in a few seconds but turns off again and the furnace stays warm. It keeps...

Furnace Blower won't stay on [ 1 Answers ]

I have a problem with my furnace blower not staying on. I can set my thermostat for say 74 degrees and the furnace will come on normally. I can hear and see the furnace on, but it takes roughly one minute (ive timed it) before the blower comes on. I know the minute delay is pretty normal;...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.