Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Briggs & Stratton 14.5 HP OHV No Compression
[ 3 Answers ]
My Riding mower has an 8 year old Briggs & Stratton 14.5 HP OHV Engine. Engine always maintained properly and has run well. While mowing, engine ran well for an hour and then suddenly quit for a split second, and backfired as it came back to life. I continued to mow and it did it again, the third...
14HP OHV I/C Briggs & Stratton Problems.
[ 15 Answers ]
I purchased this motor used around July of 07. I believe it came off a Murray riding lawnmower. It ran fine for the first three months (occasional smoking) or so then after a 2 week break of cutting it was hard starting. Took about 2-3 minutes but it started, a little smoke at start up, I made a...
20.5hp briggs, compression release valve?
[ 8 Answers ]
Do these engine have a valve to release compression to make it start easier? I think mine is stuck shut cause its real hard to turn over
14hp briggs and stratten motor
[ 3 Answers ]
Has two wires from under flywheel red and black and two other wires going behind the starter (not the starter wires) how do I use these wires to get this motor running?
B&S 18HP INTEK Valves/Compression Release
[ 1 Answers ]
Am having the same trouble as a lot of others with my 18 hp B&S Intek rider. The motor turns over 1 revolution and stops.Installed new battery and have reset the valve clearance to (.004 intake, 006 exhaust)I remember something about a gummed-up compression release causing this problem .... View more questions Search
|