Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Briggs&Stratton Pulsa Jet Carb problems
[ 9 Answers ]
I'm having trouble starting an older aerator with a B&S 3.5hp horizontal shaft engine with a Pulsa Jet carb. I've changed diaphragm, and carb-to-fuel tank gasket. It can be started and run on starter fluid, but doesn't seem to pump gas into carburetor. What else to look for?
16 H P Briggs carb takes no fuel
[ 2 Answers ]
16 H P Briggs carb will not take gas without squirting into top. Gas IS getting to carb. Wire is hot to anti backfire/fuel shutoff solenoid but it does not click. I'm told it's bad. How do you remove it. I see no threads or how to remove it. Thanks Buddy
19hp briggs new carb and stalls
[ 3 Answers ]
Hi all new to the fourum I have a question I hope you all can help. I have a murray lawn tractor with a 19 hp briggs. I put a new carb on it and the tractor runs but stalls under a load like it is running out of fuel. When I inspected the carb the bowl was full of gas and clean. The mechanic I took...
Carb tuning a 12hp Briggs (non-OHV)
[ 1 Answers ]
I am a new member who recently purchased a used Montgomery Wards riding mower (serial no.TMC 36937A/K219H). The mower had recently been painted- over red (poorly), so the ser. no. could be slightly off. I am experiencing difficulties in properly tuning the carb (i.e. the governor is kicking in @... View more questions Search
|