Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I can't pull the starter cord on my 10hp Briggs and Stratton Engine
[ 6 Answers ]
I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...
Briggs & Stratton 12.5 hp issues continue... Can anybody help?
[ 11 Answers ]
I've been struggling with problems with my 12.5 b&s vertical shaft motor. It ran low on oil a while back, it never seized... but it did stop from the friction. I simply took the head off & lubed the cylinder wall with oil & worked the piston by hand via the flywheel. I put the head back on & then...
MTD Briggs and stratton motor is having major issues.
[ 1 Answers ]
I bought this used mtd riding lawnmower. It worked fine last Saturday and I got half the yard mowed. I got off the darn thing for a minute and it would not crank not even a wisper of a sound. I jumped it off my car and it cranked right up. I did this a couple of more times and then finally on the...
Starter Rewind repair Briggs and Stratton
[ 2 Answers ]
I have a Briggs and Stratton 3.75 Spirit motor Model 98902 Type 0131 with a broken recoil spring. I can rewind the cord by hand and still start the motor. However after a year and a half of that I figure it's time to fix this! I am mechanically sound but wanted to know if there is anything I...
Briggs & Stratton 12.5 hp issues - any advice?
[ 1 Answers ]
Hi, I have a Murray riding mower with a 12.5 B&S vertical shaft motor. I recently did a dumb thing & not checked the oil for a while. Well, Here's what happened. The day the oil was low I had mowed some of the lawn & all of the sudden the engine slowed down really fast. So, I dis-engaged te... View more questions Search
|