Ask Experts Questions for FREE Help !
Ask
    mowingidiot's Avatar
    mowingidiot Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 12, 2007, 09:50 AM
    Wiring Connection on a Briggs and Stratton
    I am trying to connect the wires on a ridding mower. The engine is from the 80's and the mower is from the year 2000. The problem is the mower frame has 1 wire going to the alternator and one to the armature. The engine I am trying to connect has a two wire harness from the alternator and one killwire from the armature. Please help me figure out how to connect the wires
    Billy Barlow's Avatar
    Billy Barlow Posts: 10, Reputation: 1
    New Member
    		  
    #2

    Nov 12, 2007, 06:49 PM
    Quote Originally Posted by mowingidiot
    I am trying to connect the wires on a ridding mower. The engine is from the 80's and the mower is from the year 2000. The problem is the mower frame has 1 wire going to the alternator and one to the armature. The engine I am trying to connect has a two wire harness from the alternator and one killwire from the armature. Please help me figure out how to connect the wires
    I don'tthink you can wirem the old engine to the newer mower frame. However, there must be someone who reads these questions that know more than I.
    MOWMAN22's Avatar
    MOWMAN22 Posts: 1, Reputation: 1
    New Member
    		  
    #3

    May 2, 2012, 09:13 AM
    I replaced the engine on my rear engine toro to a bigger size .my toro now has a 8.5 briggs when I got ready to hook up the wire I had one wire (red) I knew where it went ,but there is a black wire I believe is the coil wire ,where do I splice this into or plug into.I can not find any place to plug this wire in??
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring in 5 hp briggs and stratton [ 1 Answers ]

My problem is the wiring. When I took the ON and OFF switch wire off the magneto I would get a spark. When it was on I wouldn't. So what can I do to fix that. Is it just replacing the wires or what. Thanks.

Briggs and Stratton 14.5 [ 3 Answers ]

I have a Poulan 38" cut rider with a Briggs and Stratton 14.5 hp engine. It is about 6 or 7 years old and has always ran great and has had regular maintenance (oil change and plugs, kept out of direct weather). It sat in the garage for about 2 months due to illness when my wife decided to...

Briggs and stratton [ 6 Answers ]

My briggs and stratton lawnmower was running great then started spluttering. Cleaned air filter changed spark plug still the same. Spark plug goes a sootie black colour in 30 secs. Also its pulsing badly with a bit of black smoke. Any help welcome ...

16.5 hp briggs and stratton [ 2 Answers ]

I have an older 16.5 hp Briggs and Statton riding mower,and have had the starter rebuilt. I was told that before I put it back on the mower I need to have "The Valve" turned or it would be pointless.My question is what valve needs to be turned and where is it located.I am assuming I would takr the...

Briggs and Stratton 10 hp [ 1 Answers ]

Can some one help me I need to know what valve setting to set on my briggs stratton generator. Thank you for you help

View more questions Search