 | |
| Browse | Ask | Answer | Search | Join/Login | |
Onan gen won't stay running
Asked Nov 18, 2006, 07:01 PM
—
When the "start" switch is pushed the generator will start, when released it dies. I have determined the followingIn the start cycle it recieves DC from the Battery for the fuel pump?When it is released and the generator is running it recieves volts from dc section of voltage regulator on gen set? So I am assuming that no voltage is running fuel pump when switch is released. . . Generator is 100 Miles away and wan't to be prepared for diagnostics. Is there a relay that swithces it over and has this happened to anyone else? Is the control board more likely to be bad? I have read a lot on this subject but no one addreses the relay possibility We are getting AC voltage but the generator stays on Idle, is it related to govenor? Will get wiring diagram so just looking for general practical possibilities Thanks,:) |
Check out some similar questions!
Can't seem to find that info on the net, only up to 91 (4th gen). Thanks, Phil
I have a convertible craftsman weedeater that has run like a champ - until now! I can get it to run briefly, a few minutes at most, then it dies and will not restart. After reading some similar posts I am beginning to suspect either an in tank filter or the inlet filter on the card Sound...
Mower starts but dies in 2 secs. With the air cleaner off I can keep it running by choking it with my hand. Newer briggs 6 hp. Any thoughts please!
My mother inlaw has a JD riding mower that's about 8 yrs old and has been in the weather for about the last 6 mnths, and it won't stay running unless I put the booster cables on it and jump it from my truck. It will run as long as they are hooked up but the moment I disconnect them it dies.Is this...
View more Tools & Power Equipment questions Search
