Ask Experts Questions for FREE Help !
Ask
    ccruse's Avatar
    ccruse Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 3, 2007, 05:42 PM
    Murray Lawn Tractor will not engage the trans
    iI have a Murray lawn tractor that will not endage the transmission. When I release the lever from the push mode to the drive mode it's still in the push mode. It's a model 425620X92A.

    CC
    BriggsAndStratton's Avatar
    BriggsAndStratton Posts: 20, Reputation: 4
    New Member
    		  
    #2

    May 27, 2007, 10:08 PM
    Check belt and if pulleys are spinning then your trans pulley may not be set properly causing it to spin alone without moving the shaft, happened to me also
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My Murray 12.5 hp Lawn Tractor will not start [ 1 Answers ]

Model 405004x99, 2 year old Tractor with a Briggs & S. 12.5 hp engine has a very hard time starting. It has a clean air filter; good in-line fuel filter, clean/fresh gas; oil is new and gets spark from the plug. I have had to jump start the battery from a car and (on a different occasion) a...

Craftsman Lawn Tractor Mower Won't Engage [ 5 Answers ]

I have a 18.5 HP Craftsman Lawn Tractor, model # 917.274811. It starts fine but the mower won't engage. The attachment clutch lever seems to have the same tension, and the drive belt seems fine. I've looked and can't see any obstructions. Any ideas?

Lawn tractor will not engage engine [ 1 Answers ]

The plastic gear on top of what I guess is the starter on model no.917-257631(craftsman 42') is worn down and Icannot find the part or part no. anywhere

View more questions Search