The link choke of my Murray tractor engine is loose. I could not figure out how to put it back. Can someone help? A diagram will be super. The engine model is 28v707 type 1113e1. Thanks.
Add your answer here.
Check out some similar questions!
18.5 HP Briggs and Stratton Engine [ 4 Answers ]
I have a 42" Craftsman riding mower with a 18.5 HP B&S engine. It started using oil suddenly a couple of weeks ago. The compression is 120#. What could be the problem? Also after it has been running for about 10 minutes, it shuts down. It does this with fresh fuel, new plug, clean gas tank, new...
Briggs&Stratton won't run w/o choke [ 9 Answers ]
There is no water in the fuel, replaced fuel pump diaphragm's and springs. Will start and run with the choke 7/8 closed, as I increase the throttle I can open the choke more until the throttle is wide and the choke is closed. Hellllp. It is on a 19.5 hp craftsman 42" mower ~ 8 years old. ...
Briggs & stratton 6hp engine [ 1 Answers ]
What is the proper valve setting and how are they to be adjusted?
12.5 briggs&stratton engine [ 1 Answers ]
I have a briggs &strattonengine in my ride on lawn mower the battery won't charge when the engine is running
12.5hp I/C Briggs&Stratton engine [ 3 Answers ]
I went to start my riding mower for the first time this year and when it started is smoked real bad. I turned it off and checked the oil, it was over filled. I went to drain the oil and discovered it had gas in the oil. It ran fine last year, but I didn't drain the gas out at the end of the season....
View more questions Search