Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Snowblower shear pin
[ 1 Answers ]
On my Craftsman snowblower, I need to put in a new shear pin. (model #536-886120)There are two holes on the outside of the shaft that goes through the left tire. Into which hole do I put the shear pin - the one closest to the tire or on the outside? THANKS
Pull rope broken on snowblower
[ 2 Answers ]
My pull cord (used for starting the engine) on my John Deere TRS24 from 1994 tore. I only lost one inch in the length of it so I'm trying to put it back together. I would appreciate any directions or advice. Thank you.
USA 4 pin 240v converted to Fiji 3 pin 240 v
[ 7 Answers ]
I am in Fiji with a Coleman 110v / 240v gen set and want to adapt my 4 pin female receptacle to accommodate Fiji's 3 pin 240v plugs. I know my get set is 60 hertz and the power tools here are 50 hertz.
Snow blower shear pin
[ 1 Answers ]
I broke a shear pin on my craftsman snow thrower. The head and retainer nut are sheared off properly but I don't know how to get the actual pin out of the shaft. Should I just use a small screwdriver and hammer and just knock it out? I have replacement pins. View more questions Search
|