▸ ▸ » how to start my gas leaf blower?

how to start my gas leaf blower?

Asked Nov 8, 2011, 05:03 PM — 2 Answers

I replaced my fuel line on my Craftsman blower and now it won't start. If I pour fuel into the carb it starts till that runs out. What's up?

Search this Thread

Share |

2 Answers

DG Posts: 1,297, Reputation: 566

Ultra Member

#2

Nov 11, 2011, 09:07 AM

check and make sure you didn't pinch the line ,
is there more than one line , if so make sure you didn't cross lines
check the fuel filter in the tank.
Luck

Helpful

ballengerb1 Posts: 25,644, Reputation: 11296

Home Repair & Remodeling Expert

#3

Nov 11, 2011, 05:08 PM

Was there a clunker fuel filter on the end of the line inside the tank, did you reinstall it?

Helpful

Not your question? Ask your question View similar questions

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Add your answer here.

Check out some similar questions!

Leaf blower will not start [ 9 Answers ]

How do I get a 2 year old Craftsman leaf blower to start?

Leaf blower will not start [ 11 Answers ]

I have a Craftsman 25cc leaf blower that I have been struggling with. I have taken a lot of advice here but still can not get it to start. It has spark, the carb 'looks' clean (no gunk), I can see gas pass through the tubes from the tank to the engine, and the oil/gas mixture is correct. The only...

My gas leaf blower won't fire? [ 1 Answers ]

I replaced the coil on my poulan gas leaf blower but won't fire

Gas Leaf Blower [ 5 Answers ]

I have a McCulloch 32cc Gas Blower.When I put the choke on it starts and then when I put it on run it dies out.

View more Tools & Power Equipment questions Search