I have a Toro 6.5 HP GTS lawn mower, model #12OVHO. The belt has slipped off. After removing the blade and the cover, what else do I need to remove or loosen to be able to put the belt back on the blade's flywheel?
Add your answer here.
Check out some similar questions!
Toro Lawn Mower Won't start [ 7 Answers ]
This lawn mower was given to me and it ran last year. I replaced the spark plug. Replaced the gas. Replaced the pin and the gaskets in the carb. I'm getting spark from the plug. Its getting plenty of gas... maybe too much?? After several attempts at starting it I removed the plug and...
Diagram for replacing lawn mower belt on Toro 1744HXL riding mower [ 1 Answers ]
I need a diagram for replacing the belt in the mowing deck of a Toro 17-44HLX riding mower
Replacing traction belt on toro 57360 with manual [ 1 Answers ]
1980 11hp 32" cut riding mower. Found a surprise when attempting to follow instructions. Removed blade clutch mount bolt and the cutter blade assembly is supposed to drop off the engine crank to enable belt removal. No! There is a thing called the Clutch actuator, which is used by the...
Blade belt on weedeater tractor [ 1 Answers ]
How do you change the belt that powers the blades? It seems that the deck has to be removed but I'm not sure.:confused:
Murray 14 hp 42" cut Blade Drive Belt Loose [ 3 Answers ]
What are ways of tightening the blade drive belt on a Murray Model 42813A Riding lawn mower with a 42" wide cut? Just installed new one & blades will turn while mower is stationary, but will stop while trying to run over any grass?
View more questions Search