Ask Experts Questions for FREE Help !
Ask
    debbrak's Avatar
    debbrak Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 19, 2010, 07:56 AM
    I have a craftsman generator 3500 watt that's not putting out electrical current
    On the side it says Craftsman 3500 watt 7.0hp overhead value engine model# 580.327130 serial# 5518449
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Jan 19, 2010, 04:50 PM

    Hi,
    It could have a push button circuit breaker tha pops ou to disconnect. It could also have a twist-lock fuse holder. These are what you check first.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

High saturation current in generator [ 1 Answers ]

What causes generator high saturation current

Can I use 3500 watt water heater elements to replace 3800 watts? [ 3 Answers ]

I haven't actually pulled the elements yet but the tag on the water heater shows elements rated at 3800 watts. The ones readily available at the local big box are even numbered, 3500, 4500,5500. Can I use the 3500 watt rated elements to replace elements in this water heater?

Installing Manual Transfer Switch for 7000 Watt Generator [ 1 Answers ]

I have a question about installing a manual transfer switch to be used with a portable 7000 Watt generator to power essentials during power outages. To preface this, I am going to have an electrician do the work, but am trying to get an idea of how it will work and how much parts will cost. I am...

I am trying to put the belt back on my Craftsman DLS 3500 riding Lawnmower [ 1 Answers ]

I am trying to put the belt back on my 46" Craftsman DLS 3500 Riding lawnmower I can not find find the manual . Any suggestions?

Craftsman Riding Lawn Mower Electrical Current [ 2 Answers ]

When I swiched the starter on, the riding mower wouldn't start. I didn't think that there were sparks to the plugs. I removed the end connections on each plug, took a screw driver so that there was a gap for the sparks to jump, and while my wife attempted to start the mower, I watched for sparks...


View more questions Search