Ask Experts Questions for FREE Help !
Ask

Briggs&stratton 14hp

Asked Mar 17, 2012, 03:34 PM — 6 Answers
I need to know where the wire goes that plugs into the fuel solenoid on a nikki carb on a briggs and stratton 14 hp motor.

Search this Thread
Share |
6 Answers
DG's Avatar
DG Posts: 1,297, Reputation: 566
Ultra Member
  
#2

Mar 17, 2012, 03:36 PM
how many wires does it have ?
Helpful
DougA's Avatar
DougA Posts: 5, Reputation: 10
Junior Member
  
#3

Mar 17, 2012, 03:37 PM
just the on
Helpful
DougA's Avatar
DougA Posts: 5, Reputation: 10
Junior Member
  
#4

Mar 17, 2012, 03:38 PM
just one i meant
Helpful
DG's Avatar
DG Posts: 1,297, Reputation: 566
Ultra Member
  
#5

Mar 17, 2012, 06:28 PM
there should be a spade on the bottom of the solenoid , it plugs in there.
Luck
Helpful
DougA's Avatar
DougA Posts: 5, Reputation: 10
Junior Member
  
#6

Mar 17, 2012, 06:45 PM
well i kinda figured that but where does the other end suppose to connect too?
Helpful
DG's Avatar
DG Posts: 1,297, Reputation: 566
Ultra Member
  
#7

Mar 17, 2012, 07:57 PM
Sorry my bad . it goes to the hot wire in the engine plug,
turn key to on not running check for current in plug there is only one hot when engine is not running .
Luck
Helpful
Not your question? Ask your question View similar questions
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Add your answer here.

Remove Text Formatting
 

Undo
Redo
  
Decrease Size
Increase Size
Bold
Italic
Underline
Align Left
Align Center
Align Right
Ordered List
Unordered List
Decrease Indent
Increase Indent
Insert Email Link
Wrap [QUOTE] tags around selected text
Wrap [CODE] tags around selected text
Wrap [HTML] tags around selected text
Wrap [PHP] tags around selected text
Wrap [YOUTUBE] tags around selected text
Notification Type:



Check out some similar questions!

14HP OHV I/C Briggs & Stratton Problems. [ 15 Answers ]

I purchased this motor used around July of 07. I believe it came off of a Murray riding lawnmower. It ran fine for the first three months (occasional smoking) or so then after a 2 week break of cutting it was hard starting. Took about 2-3 minutes but it started, a little smoke at start up, I made...

14hp Briggs and Stratton blows smoke/oil out exhaust [ 6 Answers ]

I was given a neglected zero turn mower that had been used regularly for the past several years. After charging the battery I started it up and let it idle for a few minutes before trying to move. I did notice that it seemed to be smoking a bit and once I increased the speed, the engine blows a...

How to adjust valves on 14Hp Briggs&Stratton engine [ 1 Answers ]

The lawnmower will not crank, has to much compresssion. The engine will not turn over.

Compression release 14hp briggs stratton [ 1 Answers ]

How to adjust compression release 14 hp briggs engine ohv,

Briggs &stratton 15 hp. [ 1 Answers ]

The other day this engine just quit and I had no spark from the coil. It has the electronic ignition so I cleaned everything under the flywheel and put it back thinking that this must be the problem but no. There is a small wire that goes to the coil and when I pull it off it will fire. I found two...

View more Tools & Power Equipment questions Search