Ask Experts Questions for FREE Help !
Ask
    sandersp13's Avatar
    sandersp13 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 2, 2010, 07:56 PM
    38608x12c murray lawn tractor
    It has been a while since I have rebuilt a starter for my murry rider . How do I hold the brushes in while putting rear cap back on . Have tried paper clips and starts to work but then they pop loose before it all togather. 12 hp single cylinder 38 cut 38608x12c date code 3160
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 3, 2010, 04:13 PM

    Hi,
    Put the commutator/armature in the base and hold down and in place as you put the assembly up into the magnet/outer case.
    Peace,
    Clarke
    Conchambassador's Avatar
    Conchambassador Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Jul 2, 2012, 10:52 AM
    Its probably not worth rebuilding that starter. When mine went out, I replaced the entire starter at Auto Zone for under 20 bucks. Much easier, I assure you!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Murray Lawn Tractor Transmission [ 5 Answers ]

How can I check the transmission fluid level in a Murray Select Wide Body LT Lawn Tractor, 21 hp, 46" cut, MFG date 8.21.02. I can find NO help at the Murray website. Thanks, Phillip

Murray lawn tractor not starting [ 2 Answers ]

I have a murray lawn tractor and I hit a rock with the blade the other day and it went off. Now the tractor starts and crank but the engine doesn't turn over. It will start initially but the engine doesn't say on but for three seconds before going off again. Does anyone have any ideas, help?

Murray 12.5 lawn tractor won't go [ 1 Answers ]

Murray 12.5 lawn tractor won't go into any gear. The runs but no movement forward or reverse

Murray lawn tractor [ 3 Answers ]

I have a murray/stanley lawn tractor that has not been used in over an year. I replaced the batteries and added fuel and managed to start it up. I did also take the safety switch off under the seat since it was corroded. However when I take my foot off the clutch to move it or lower the blades,...

Murray 38608X12C [ 1 Answers ]

I am trying to replace the solinoid on a murray tractor model # 38608X12C. The new part does not crank. Anyone have a color coded wiring diagram for this machine? <moved>

View more questions Search