Ask Experts Questions for FREE Help !
Ask

24hp briggs intek

Asked Jun 27, 2009, 07:55 AM — 1 Answer
The carb seems to be overloading and one side has condensation on the intake.Does not seem to have full power. I have checked to see if it getting fire, changed the plugs, replaced all fuel lines and filters to so far. Any suggestions?

Search this Thread
Share |
1 Answer
crigby's Avatar
crigby Posts: 3,747, Reputation: 466
Outdoor Power Equipment Expert
  
#2

Jun 29, 2009, 05:14 AM


Hi,
If you have fuel condensation on one side, I would say you have oicked up a small piece of trash in the inlet needle. The unusual thing about thea carb is that the two throats join and balance just before entering the manifold. It may look as if it is a two barrel carb, but it really is not. The one thing I have found is that today's fuel leaves much to be desired. Cheap fuel filters do not well well and good ones clog because of that.
If you are getting too much fuel, it is not being burned or having its arrival into the carb's circuitry properly controlled.
Peace,
Clarke
Helpful
Not your question? Ask your question View similar questions
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Add your answer here.

Remove Text Formatting
 

Undo
Redo
  
Decrease Size
Increase Size
Bold
Italic
Underline
Align Left
Align Center
Align Right
Ordered List
Unordered List
Decrease Indent
Increase Indent
Insert Email Link
Wrap [QUOTE] tags around selected text
Wrap [CODE] tags around selected text
Wrap [HTML] tags around selected text
Wrap [PHP] tags around selected text
Wrap [YOUTUBE] tags around selected text
Notification Type:



Check out some similar questions!

Engine switch V twin briggs for Briggs intek ohc [ 2 Answers ]

I would like to exchange a 19 hp V Twin into a Craftsman lt 2000 mower. It was originally equiped with a 22 hp Intek V OHC. I am wondering how different the wiring is going to be. Also is this possible? The 19 HP twin is Model 42A777 Type 1236 01. The Intek is Model 407777 Type 0174 E1 Thank...

Briggs and stratton 14.5 I/C intek [ 1 Answers ]

I need the compression spec for the Briggs 14.5 intek engine. Thank You Kindly Louis D'Amico

Briggs and Stratton Intek won't start [ 9 Answers ]

Hi, I have a new Husquvarna LGT2654 (purchased March 29th) with the Briggs and Stratton Intek V-Twin. It's run fine until now. It's been extremely Hot & Dry in the Memphis, Tn. Area and it's been about 3 weeks since I had to cut the grass... Now it cranks and cranks but won't start. I...

View more Tools & Power Equipment questions Search