Ask Experts Questions for FREE Help !
Ask
    snapperman's Avatar
    snapperman Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 29, 2008, 08:00 AM
    10hp briggs carb adjustment
    My snapper mower boggs down when blades are engagued runs good with no load. Have done all the tune up things carb clean twice ,plug,filter, gas , think carb may be out of adjust any suggestions or carb settings. Thanks.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #2

    Apr 30, 2008, 05:08 PM
    When you cleaned the carb, did you remove the welch plug and clean the ports there? Did you rod out the jets? Did you check the condition of the screw in jet tips?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

10HP Briggs and Stratton Generator Engine [ 24 Answers ]

Hi Guys, Recently, I was using my Generac 5550 generator with a 10HP Briggs & Stratton OHV, model 204412, Type 0142 engine, and it started running rough and puffing black smoke. So I bought the repair manual. Took everything apart to the piston, cleaned the carbon off the pistons and...

I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]

I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...

Briggs 14.5 oil in carb [ 2 Answers ]

I have a rider with a briggs 14.5OHV. It will run for a little bit then oil pours into the carb from a breather I'm guessing? Is the breather bad or do I have bigger problems.

Briggs no flow carb ? [ 17 Answers ]

I have a 1997 mtd Yardman 18.5 hp.tractor. I have a no start no run condition which I've tried to trouble shoot. I removed the air cleaner and have been able to run gasoline primes through the air horn so, the ignition system seems to be OK. Secondly, I removed the gas line from the inlet of the...

Oil getting into carb on 16 hp Briggs [ 1 Answers ]

I have a lawn tractor with a 16 hp Briggs engine. It burns oil. I put Lucas oil in and it helped. However the problem is back! There is oil showing up in the air filter. Obviously the engine smokes. What are the possible causes?


View more questions Search