Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier propane furnace - flashing code
[ 1 Answers ]
Hi everyone! I have a Carrier propane furnace and it is flashing a code. One long flash and four short flashes. Can anyone help? This furnace is only 5 years old. Thanks so much!
1 hour lockout - What next?
[ 3 Answers ]
I have a Rheem Criterion II gas furnace. The unit starts and runs okay most of the time. However it will stop occasionally and will go into 1-hour lockout mode (based on light codes) . What is causing unit to work properly sometimes and not others? I have checked the orange flame light. It...
York furnace troubleshooting- getting code #8 Ins lockout due to recycle?
[ 1 Answers ]
I have a York model P2MP020n11201A BLowing lukewarm air. Giving a code #8 INS lockout due to recycles. Thermastat reads 55 degress. Shuts off in 10-15 minutes.
Trane Furnace error code = 2 flashes, what does system lockout mean?
[ 1 Answers ]
I have a Trane forced air furnace which recently has had periods when it blows unheated air. When I looked at the furnace during these periods it shows 2 flashes, which according to the instruction manual is an error code which means: System lockout, retries or recycles exceeded. I don't...
Carrier Ignition Lockout Code & Ignitor Problem
[ 3 Answers ]
The code I'm getting is 14 for ignition lockout, will reset in 3 hrs. The furnace tries to ignite 3 or 4 times and then the code trips and shuts the furnace down. I usually just flip the manual switch to get it going again but if I'm not home to pay attention or if we're asleep the house will... View more questions Search
|