Ask Experts Questions for FREE Help !
Ask
    JeffKelwood's Avatar
    JeffKelwood Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 2, 2007, 02:53 PM
    Correct size of Return Air Vent Opening
    What is the correct size for a return air vent opening if I'm using a 4-ton 13SEER A/C?

    Thanks!

    Jeff
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Apr 2, 2007, 04:28 PM
    Use a duct O later or other sizing tool for the calculations. Usually you will have more than one return air in a house and you also have to deduct to grill cover from the duct size to assure yourself of enough square inches of duct opening. That is why I do not do generic sizes as you requested.
    SuperTyphoon's Avatar
    SuperTyphoon Posts: 85, Reputation: 5
    Junior Member
    		  
    #3

    Apr 3, 2007, 08:24 AM
    Basically, the bigger it is, the less noise it makes. The air taken in will be the same regardless of how big you make it.

    Just don't make it too small otherwise it will make a hissing noise.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Return Air vent sucking air... and being really loud about it [ 5 Answers ]

In the middle of our living room is a return-air vent. It goes straight up to 2 of the bedrooms upstairs also. When the furnace kicks on, the noise coming from the vent down here is rediculously loud, almost to a point where nothing else is distinguishable above the wind sound. The furnace's...

Loud Air Return Vent [ 23 Answers ]

I have a small 850sqft condo. Lived her a couple of years. I have an old Borg Warner 65000 input BTU/HR unit. Model P3UGD080N6501A. Its an older unit. There is only one return in the condo which is located on the far side of the living room, connecting directly to the HVAC unit which is on the...

Sealed return air vent [ 2 Answers ]

We just purchased a home built in the 50's, and the grill for the return air vent in the hallway is sealed with tape and aluminum foil. It seems to be pretty tight, as if whoever sealed it had a really good reason to do so. What would the reason be for doing this? We can't decide if we are going...

Cold air return vent [ 1 Answers ]

I bought a home recently that has gas heat. It has a crawl space not a basement. The cold air return register put our cold air. I always thought the cold air return register takes the room cold air and returns it to the heater. Am I correct and if so have do I correct it.

Basement return air vent [ 2 Answers ]

Carrier, modal 58MAC120-20, direct air forced air furnace, seven years old in a 2,700 square foot home seven years old. The basement is 1,200 square feet, open and half finished, has two supply air regesters and no return air vent. What size "opening" is recommended for this area?

View more questions Search