Ask Experts Questions for FREE Help !
Ask
    shockawa's Avatar
    shockawa Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 4, 2007, 09:30 PM
    Hunter thermostat--no AC message
    I have read other questions and answers but still getting no where===While I do get this message---I have also checked with my meter and am getting voltage back through --but a tad more than the 24.6==actually getting about 26.1--other than that I see nothing wrong--but still get the dang NO AC POWER message---Any suggestions appreciated!

    Thanks

    Ralph
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Mar 5, 2007, 03:56 PM
    Sounds like the stat is bad if you have verified 22-28 volts from R to C terminals.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hunter Thermostat wiring [ 6 Answers ]

Hello! I seem to have "developed" a problem tonight. I just removed my old manual thermo and labeled the wiring accordingly. It looked the heat hot came into a spot labeled "4". Then it was jumpered to Rc. So when I hooked up the Hunter programmable 44360, there was already a jumper between Rc and...

Hunter To Honeywell Thermostat [ 1 Answers ]

I recently purchase a Honeywell RTH6300B to replace a Hunter 44402 problem is there are only two wires coming out of the wall one White and One Black where do these wires go on this Honeywell? Thanks JIm

Wiring help needed- new hunter thermostat [ 6 Answers ]

I have an old 1980 era mercury analog thermostat, and want to replace it with a programmable one. The system coontosl a gas furnace with external compressor. The old t-stat is a general electric, and has the following wire conventions: Wire Terminal Green G...

Need Help with Hunter Thermostat Please [ 4 Answers ]

I have a Payne PF1MNC hvac, and just replaced my White Rodgers thermostat (It wasn't blowing hot air or kicking in in Auto mode) with a Hunter 44155C. There were 4 wires attached: G to G R to Rh (with jumper) Y to Y1 W to W And an unattached B I attached them the same to the Hunter:

Rheem to Hunter Thermostat [ 1 Answers ]

Currently, I'm trying to replace an old rheem thermostat with a hunter Model 44155C. The wiring colors are confusing to a novice like me. There are five wires: red, green, blue, yellow and white. The hunter thermostat has connections for RH, RC, G, Y/O, W/B, and Y1. The only two wires that I...

View more questions Search