 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
It could be caused by a wind draft blowing out the pilot. It could need a new thermocouple, It could be that you are using most of the hot water and as it heats the new water condensation is forming and dripping on the pilot and putting out the pilot.
Just some thoughts. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The pilot light on my gas water heater will not stay lit. I can light the pilot light, but when I release the valve, it goes out.
I have a Whirlpool water heater that is only about 3 years old. About a year after we installed it, we had to replace the thermal couple (I think that's how you spell it) because the pilot was not staying on. Well, it's happening again. When we notice there is no hot water in the house, we go...
My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...
Pilot went out, no problem relighting. BUT when I turn up the thermostat, the flame gets out of control and escapes from the two protective doors. It has started melting the plastic on the outside of the tank around the drain valve.
View more questions Search
|
