Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ariens old snow blower with problems!
[ 4 Answers ]
Well my friends gave me an older my guess is 1980s snow blower with and 8 horse power motor, it did not run my guess was the carb,took it apart sprayed the holes and got as much junk out of the tank as I could put it back on and did not fire up it tried but there was not gas coming into the...
Remove knobs - honda hs35 snow blower
[ 9 Answers ]
My aged Honda HS35 Snow Blower runs like a dream and usually started at the first pull. However, the sort of u-shaped wire at the bottom of the Choke Knob shaft somehow came loose from wherever it is supposed to connect to. The wire is still connected to the Choke Knob shaft at the other end. I...
Ultra by murray snow blower
[ 1 Answers ]
Hello, Looking for impeller for ultra murray model f2484020,code5212,ser002313337309 8hp,hmsk80, any help thank you greg
Snow blower
[ 1 Answers ]
I got a new snow blower last year and used it once, worked great, this year it won't start. Primer is just pushing air, gas line is not bloked. I put I little gas in the spark plug cylinder and it fired up for a second. Gas is not going through the carb, is something stuck, what should I do. I did...
Snow blower shear pin
[ 1 Answers ]
I broke a shear pin on my craftsman snow thrower. The head and retainer nut are sheared off properly but I don't know how to get the actual pin out of the shaft. Should I just use a small screwdriver and hammer and just knock it out? I have replacement pins. View more questions Search
|