Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Low pressure cut-off switch problem
[ 4 Answers ]
My well occasionally runs dry, so I recently replaced my pressure switch with a Square D switch with the low pressure cut-off to protect the pump. It is set for a 40-60 psi range (same as the old one). Now about half the time, when when it reaches the 40 psi cut-in, the pressure suddenly drops...
York residential furnace pressure switch problem code stuck switch
[ 1 Answers ]
I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals
Residential well pump: pressure tank/switch problem
[ 0 Answers ]
I lose water pressure completely for about 10 sec. while running the water. This happens approx. every 5 min while the water is running. I've replaced the pressure switch several times, but it only helps for maybe six months before the water pressure is affected. Is this a well pump problem or a...
Miller trailer furnace problem
[ 4 Answers ]
:confused: I have a Miller oil furnace in my garage that burns very dark orange and sooty. It also keeps burning inside after the unit shuts down. I have replaced the nozzle twice with no change. The flue from the top of the unit all the way through the roof is clear. Any ideas??
Goodman gas funace pressure switch problem
[ 9 Answers ]
I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure... View more questions Search
|