 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore washer dryer combo won't drain
I have a kenmore washer dryer combo that will do everything up to the spin cycle and won't drain If it is a clogged drain filter how do I get at it. Is it underneath or is there some way I am supposed to take the front of the washer off to get at it.
|
||||
|
||||
|
You should be able to take off the front panel of washer to access the pump. Kenmore models however, can be made by anyone, Frigidaire, GE, Whirlpool, etc. so the precedure for the access panel can be different. Try a Putty Knife and slide under from of lid and try to pull the front panel off. Otherwise, look for screws on the bottom of the front panel. Take this off, tilt upwards and remove. Rich Western Appliance Repair of Boise |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The washer will fill and it will agitate for about 10 seconds, then it will stop.When it stops there is no motor sound.Then after about one minute it will start by itself and repeat the same thing over and over no matter what I set the knob to it does the same thing. Could it be the timer?
My washer will not drain the water out at the end of the rinse cycle. It makes a humming sound. Ten the spin cycle works fine. Please help
I have a kenmore washer dryer combo model 417.94842301. I am trying to replace the start knob for the dryer and am having difficulty getting the knob for the washer to remove. How do I remove the knob for the washer?
My Kenmore model # 110.98575100 washer dryer combo will not spin when it reaches the spin cycle unless I lift the lid and close it again. I don't really know how old it is, but it is at least 5 years old. I have replaced the lid switch, but that did not work. It makes a noise like the motor is...
Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...
View more questions Search
|
