Check out some similar questions!
Removing glued ABS fitting to ABS piping
[ 5 Answers ]
I glued an ABS toilet flange to ab ABS pipe roughing. The fitting did not go down all the way and is 1/2" proud of the tile flooring. I now want to remove the fitting and replace with a new fitting. How do I do it without damaging the receiving pipe. Pipe is in concrete floor. Thanks, Bob
7.3 power stroke glow controler how do I check
[ 1 Answers ]
I don't think my glow plugs are working at all. When cold it starts without a problem. When plugged in it starts without a problem. But when left for several hours in the cold, it is extremely hard to start and sometimes it won't start. Is there any way to insure the glow plugs are getting power,...
Three zone controler interface
[ 5 Answers ]
Hello I have a vision pro 8000 thermostat-2 hooked to a three zone controller tied to a 2 stage gas furnace and a 2 stage heat pump. The heat pump works but the gas will not come on unless I change the zone controller from heatpump to conventional. Then the a.c. comes on instead of the heatpump on...
Furnace fan controler testing
[ 2 Answers ]
I have a fan controler with high temp shut off.is there a way to test the fan controler while not on the burner? View more questions Search
Add your answer here.
|