Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman GMNT, noise and blower speed
[ 4 Answers ]
I have a GMNT 120-5, the vent motor is extremely noisy during operations and can be heard in the entire house. Any possibility to repair or should I just replace the motor? After a recent service call the technicians switched the blower speed to a higher level which due to the high velocity now...
Goodman gmnt-100 won't light
[ 5 Answers ]
My goodman gmnt100 won't light just replaced the ignitor about 3 weeks ago was working fine and then started lighting intermittantly now won't go at all
12 gauge wire @ 160 ft with 120 v and 14 amps will it work
[ 1 Answers ]
Need to know if the amperage will be enough when it gets to the pump off a 20 amp breaker
240 2 pole with 120 split off
[ 1 Answers ]
Folks- I am building a special project box and can't figure out why my breaker keeps tripping... I have a 240v 2 pole GFI breaker 30 amps supplying power to the box via 4 wire 10/3 feed. Inside the box, on the back side of the outlet power comes in on, I'm tapped/bridged off one of the...
Goodman GMNT Furnace Not Running
[ 28 Answers ]
I have a Goodman GMNT High-efficiency Condensing Gas Furnace that is not coming on. It is 5+ years old and had been working fine until the last couple of days. Fortunately, weather is getting better (Spring!), so need for heat is low. It is a horizontal installation, located in the crawl space... View more questions Search
|