Ask Experts Questions for FREE Help !
Ask
    drllnl's Avatar
    drllnl Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 26, 2007, 07:41 AM
    Stihl chainsaw 041
    I have a stihl 041 chainsaw that starts OK but when it gets warmed up will not run full throttle. It runs very well at all speeds until it gets warm.
    blue77's Avatar
    blue77 Posts: 13, Reputation: 1
    New Member
    		  
    #2

    Jun 6, 2010, 03:14 PM

    Stihl instruction manuals are available from the following website:

    Stihl Instructions - Stihl Manuals - Stihl Guides

    Good Luck
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #3

    Jun 6, 2010, 08:11 PM

    Check your muffler and exhaust ports.
    Catch 5049's Avatar
    Catch 5049 Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Jul 19, 2012, 04:55 AM
    I have an 041 stihl and after running a short amount of time the chain jams up. The clutch is free but the sprokett is seized up. Could it be something wrong with the oil pump? It oils well. Thanks
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Best Chainsaw [ 4 Answers ]

I own a craftsman chainsaw w/3.3hp and 20inch bar. I have owned this saw for 20 years and I am looking to replace it.. I am looking to replace it with a like size saw but I want to purchase the best saw for my buck... I am looking at Craftsman, Stilh, Husqvarna, and Shindaiwa. All comments are...

Stihl weedeater [ 1 Answers ]

My stihl fs85 trimmer runs for about 2 minutes then starts to bog and dies? Help

Gas/oil ratio for chainsaw [ 1 Answers ]

I have a craftman's lightweight chainsaw 2.0 cubic inch and I am not sure what gas/oil ratio to use, can anyone help me?:p

Chainsaw dilemma [ 3 Answers ]

I have a shindaiwa chainsaw that I haven't started lately... It is a 2 cycle. I would like To know if it is okay to use just a touch of starter spray in the spark plug area to try and Get it fired up. Thanks for the input... Kellyw.

Chainsaw stalls when turned [ 3 Answers ]

Ok, so I have an old Homelite XL-12. It cuts fine for my needs, except it has began stalling and running erratically. This is especially evident if the saw is turned on its side, it will almost certainly stall within 5-10 seconds.:confused: I have replaced the fuel line and filter. I am not sure...

View more questions Search