Ask Experts Questions for FREE Help !
Ask
    photo_chick's Avatar
    photo_chick Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 1, 2006, 04:00 PM
    Briggs&Stratton engine 121602
    OK, Dh and I are havig a slight disgreement about the mower. It is a Murray, sold under the Scotts brand in 2000, with a briggs and stratton 6.5 hp engine number 121602.

    Now, a cable broke, the one from the handle that kills it when you let go, and it sat outside for a month while we got the cable. REplaced it then the mower would not start. I thought it sounded like it was not getting any gas. It would turn over, but not fire. Now after replacing all the usual (spark plug, oil , air filter) still would not start. Dh finally listens to me and pulls off the fuel line because gas is leaking out the primer bulb. I said, hey, maybe somethig is gunked up because you left it outside for a month? He takes the fuel line there off and pumps the primer bulb to see if it works. After a few tries you can tell something was cleared out of it. You could hear it woosh now. He puts the fuel line back, and starts it up. Now it starts, but it idles at full speed. WAYYYY to fast. Anyway, he spends the day on the phone with his brother, and they go through a lot of things. He took stuff off, put stuff back. I don't know what else. Now it starts just fine, but after about 30 seconds it begins to rev up and down. Almost dying, then going back up. It does not go back up to as fast as it was before though. I say it sounds like something is gunked up in there still.

    Anyone have any suggestions? My DH is a wonderful game developeer, but not very mecahnical. My mecahnical expertise is limited to installing light fixtures and building computers! Any ideas would be greatly appreciated.
    thebriggsdude's Avatar
    thebriggsdude Posts: 1,096, Reputation: 53
    Ultra Member
     
    #2

    Oct 2, 2006, 01:22 AM
    How old was the fuel that was sitting in it over a month... letting it set with un-stabilized gas (after a month, it starts to go bad without, later on it gets rancid then gummy) And of course if it set in the rain?! It may have water in the carb, and tank...

    The reving sounds maybe like a air leak... which can be easily detected by carb or brake cleaner sprayed around the carb seals.
    bedorr's Avatar
    bedorr Posts: 2, Reputation: 1
    New Member
     
    #3

    Jun 25, 2007, 09:53 PM
    Quote Originally Posted by photo_chick
    ok, Dh and I are havig a slight disgreement about the mower. It is a Murray, sold under the Scotts brand in 2000, with a briggs and stratton 6.5 hp engine number 121602.

    Now, a cable broke, the one from the handle that kills it when you let go, and it sat outside for a month while we got the cable. REplaced it then the mower would not start. I thought it sounded like it was not getting any gas. It would turn over, but not fire. Now after replacing all the usual (spark plug, oil , air filter) still would not start. Dh finally listens to me and pulls off the fuel line because gas is leaking out hte primer bulb. I said, hey, maybe somethig is gunked up because you left it outside for a month? He takes the fuel line there off and pumps the primer bulb to see if it works. After a few tries you can tell something was cleared out of it. You could hear it woosh now. He puts the fuel line back, and starts it up. Now it starts, but it idles at full speed. WAYYYY to fast. Anyway, he spends the day on the phone with his brother, and they go through a lot of things. He took stuff off, put stuff back. I don't know what else. Now it starts just fine, but after about 30 seconds it begins to rev up and down. Almost dying, then going back up. It does not go back up to as fast as it was before though. I say it sounds like something is gunked up in there still.

    Anyone have any suggestions? My DH is a wonderful game developeer, but not very mecahnical. My mecahnical expertise is limited to installing light fixtures adn building computers! Any ideas woudl be greatly appreciated.
    There are a several possibilities. There could be water in the fuel, a bad diaphragm or a bad spark plug. The fast idle is more than likely caused by the throttle stuck in the wide open position due to being in the elements. Hope this helps.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #4

    Jul 7, 2007, 07:00 AM
    All Of The Previous Answers Are Good Ones. But It Could Also Be A Malfunctioning Governor (although Not Very Likely), Or Even More Common Could Be The Spring On The Carb Off, Or Set Improperly.
    Good Luck.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs & stratton 12.5 [ 8 Answers ]

My husband has an MTD with a b and s 12.5. It has run weill with some babying for a while, now. One day he was running ti and he heard a loud POP , and that was the end. It has new solenoid, starter, bettery and a few other things . The key is it is GETTING gas into the bowl, but not going ...

I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]

I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...

Briggs & Stratton 14.5hp OHV - Won't Run [ 8 Answers ]

I have a yard machine mower that was running great. It shut off in the middle of cutting and that was that. If I pour gas in the carb it tries to start, so I know I have fire. I have plenty of gas going to the carb and the solenoid on the bottom is working fine. I had the carb off, took the main...

Briggs &stratton 15 hp. [ 1 Answers ]

The other day this engine just quit and I had no spark from the coil. It has the electronic ignition so I cleaned everything under the flywheel and put it back thinking that this must be the problem but no. There is a small wire that goes to the coil and when I pull it off it will fire. I found two...

Briggs & stratton 16hp [ 1 Answers ]

Hi, I have a Cub Cadet which had a 16hp BS motor with points. It went bad so I found another 16hp BS that does not have points, it has the magnetron ignition. I am having trouble getting it to fire, is there something that I need to change to the wiring to make it fire. The magnetron engine came...


View more questions Search