Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant Heater Pilot won't light.
[ 2 Answers ]
I have an old bryant unit . It has worked fine until the other day. Blower works fine but no heat. Pilot was out so I lighted it and it worked fine for the night. The next day no heat again. Pilot was out again. Trie to light but will not light. Friend told me to replace the therm coupler. Here is...
Bryant furnace blowing cold air and pilot won't lite
[ 1 Answers ]
Hello, I purchased a Bryant gas furnace about 10 yrs ago. When I woke up this morning it was blowing cold air. My brother went down and looked at it and there was a red "led" light flashing on/off when he tried to get it to start back up. It was liting but now it isn't. Please help! :confused:
Bryant 50-394U won't light or blow
[ 1 Answers ]
I am trying to help my elderly neighbor she has an older Bryant SM-E 50-394U. It had a wire that tied into the thermocouple that I noticed was melted when I went to light the Pilot light for her (my first time for her). She said before I replaced the wire she did have fans and AC, but no heat. I...
Bryant furnace does not come on
[ 3 Answers ]
We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house. When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners...
Bryant furnace starts then stops
[ 3 Answers ]
My Bryant forced hot air furnace gets the signal to ignite, the pilot light and then the furnace lights but it goes out in a few seconds. This will happen over and over and then occasionally it might stay lit and warm the house. Any ideas of what this could be and how to fix it. Much... View more questions Search
|