Search:

Contact the party you acquired it from and tell them to give you their Username and Password.

From what I read about the Rogers Hub it also has RJ45 ports for connecting a CAT5 cable from the hub to your PC. Is that how you're connected, or is the PC connected wirelessly?

192.168.1.1 is...

All right, understood. Need to know a few things first.

1] As it's wireless 3.5G signal transmitted from the Rogers Hub, how many bars (signal strength) do you see on your cell phone? If your...

No. Hewlett Packard is not a hard drive manufacturer. The following list of hard drive manufacturers is current as of August 2011. This list does not include all manufacturers of SSD storage devices.

As the Rogers Hub is a proprietary 3.5G/HSPA network device, manufactured by Rogers for use in Canada, it would make a lot more sense for you to contact them directly with your complaint. They offer...

Sorry... Dell laptop... forget the part about the power cord and peripherals, but everything else applies. Dell's are easy to get into. If you need a users manual to help you, and you don't have one,...

OK, take a step back and perform these basic troubleshooting steps;

1] Shutdown, disconnect the power cord from the power supply connector, disconnect all peripherals, then open the case.

2] ...

Run fixboot and fixmbr again with these switches:

fixboot \Device\HardDisk0

fixmbr \Device\HardDisk0

Then run the bootcfg command. If /list doesn't show any entries, run /scan. If /scan...

Your board has two SATA connectors and two IDE connectors. You don't state how your drives are connected so trying to answer your question is pretty much a fail. Try another post that includes an...

If you have an email client installed on your Mac, and you created then sent those emails from your email client, and you haven't done a compact and rebuild, then yes there is a good chance that you...

Without more info it appears that the boot sector is corrupt. As you already know how to access the Recovery Console, go back in and run these two commands at the prompt:

FIXBOOT (press enter)...